How to adjust the hydraulic brake

The spacing of the brake pads needs to be adjusted, and the adjustment method is as follows:
1. In order to ensure the normal operation of the braking device, there is a brake shoe over-wear travel switch and a disc spring fault switch on the braking device;
2. During normal operation, the gap between the brake shoe and the brake disc and the maximum oil pressure gap after the adjustment of the brake input is generally adjusted to 1 mm. Excessive wear stroke switch action, safe braking, at this time will have to adjust the brake pad clearance;
3. When adjusting the gate gap, adjust the pressure oil to the maximum, so that the brake is in the state of fully releasing the gate, then adjust the adjusting ring to push the cylinder, gate and other components to move forward until Meritor slack adjuster Bendix slack adjuster the gate gap reaches 1mm.
Everyone's habit of braking soft and hard is different. Generally, German cars and some American cars have hard brakes, while Japanese cars have relatively soft brakes. These are all adjustments made by different manufacturers. Changes are allowed, and 4S stores are not allowed to change in principle. Even if you have to find a repair shop to adjust it yourself, you must find a professional. After all, it is about driving safety, not a child's play.
The brakes are hard and sensitive, and the braking force responds more quickly, but it is difficult to grasp the braking force when driving at low speed, which is prone to unnecessary sudden braking and nodding, resulting in a bad riding experience and even rear-end collisions. If the brakes are soft, the braking force is better controlled when driving at medium and low speeds, but more force is required when a larger braking force is required.
When you find the position to adjust the brake, you will find it along the brake line, and you will find a screw for adjusting the brake. We use this screw to adjust the brake clearance, which is the sensitivity of the brake.
The process of adjusting the brake: the wrench loosens the screw, the pliers tighten the wire, and adjust the brake clearance.
Adjust the gap of the brake, the tightness is appropriate, and tighten the adjustment screw.
Test whether the brakes are reliable and not too tight. If there is a problem, repeat step 2 and readjust the brakes until the problem is solved.
FJ Part No. OEM No. Spline Camshaft Arm Length (Span)
FJH410211 400-10211 1 - 1/2" - 28 5.5"
FJH410212 400-10212 1 - 1/2" - 28 6"
FJH410214 400-10214 1.625" - 37 6"
FJH410215 400-10215 1 - 1/2" - 10 5.5"
FJH410216 400-10216 1 - 1/2" - 10 6"
FJH410140 400-10140 1 - 1/2" - 28 5.0" - 6"
FJH410141 400-10141 1 - 1/2" - 28 5.5" - 6.5"
FJH410142 400-10142 1 - 1/2" - 10 5.0" - 6"
FJH410143 400-10143 1 - 1/2" - 10 5.5" - 6.5"
FJH410144 400-10144 1 - 1/2" - 28 6"